Vol. 2 No. 1 (2011)

Articles

• Preface and table of contents

  Jeroen Van Wittenberghe

  • PDF

• Experimental and numerical investigation into effect of elevated temperature on fretting fatigue behavior

  R. Hojjati Talemi, M. Soori, M. Abdel Wahab, Patrick De Baets

  2-11

  • PDF

• Dry sliding friction and wear response of WC-Co hardmetal pairs in linearly reciprocating and rotating contact

  Yeczain Perez Delgado, Koen Bonny, Patrick De Baets, Patric Daniel Neis, Vanessa Rodriguez Fereira, O. Malek, J. Vleugels, B. Lauwers

  12-18

  • PDF

• Characterization and modeling of friction and wear: an overview

  F. Al-Bender, K. De Moerlooze

  19-28

  • PDF

• Tribological behavior of composite-steel on rolling/sliding contacts for various loads

  M. Ando, Jacob Sukumaran

  29-34

  • PDF

• Height-independent topographic parameters of worn surfaces

  I. Barányi, Á. Czifra, Gabor Kalácska

  35-40

  • PDF

• Review and classification of fretting fatigue test rigs

  Jan De Pauw, Patrick De Baets, Wim De Waele

  41-52

  • PDF

• Degradation of carbon reinforced epoxy composites under sliding in ambient air

  H. Dhieb, J.G. Buijnsters, J.P. Celis

  53-58

  • PDF

• Turning specialities of ZrO2 ceramics

  G. Fledrich, I. Pálinkás, R. Keresztes, L. Zsidai, K. Petróczki

  59-65

  • PDF

• Improved handling characteristics of off-road vehicles by applying active control of steering wheel torque

  J. Kis, L. Jánosi

  66-74

  • PDF

• Development environment for haptic feedback device on mobile agricultural equipment

  L. Jánosi, J. Kis

  75-81

  • PDF

• Abrasive wear of different hot-dip galvanized multilayers

  L. Szabadi, G. Kalácska, L. Pék, I. Pálinkás

  82-91

  • PDF

• Investigation of friction hysteresis using a laboratory-scale tribometer

  Patric Daniel Neis, Patrick De Baets, Yeczain Perez Delgado, N.F. Ferreira

  92-98

  • PDF

• Developing small-aircraft service and re-construction of landing-gear leg support

  R. Lefánti, Gabor Kalácska, I. Oldal, K. Petróczki

  99-105

  • PDF

• Machinability of engineering polymers

  Robert Keresztes, Gabor Kalácska, L. Zsidai, Z. Dobrocsi

  106-114

  • PDF

• Roughness measurement problems in tribological testing

  Vanessa Rodriguez Fereira, Jacob Sukumaran, Matyas Ando, Patrick De Baets

  115-121

  • PDF

• Effect of velocity on roll/slip for low and high load conditions in polymer composite

  Jacob Sukumaran, Matyas Ando, Vanessa Rodriguez Fereira, Patrick De Baets

  122-127

  • PDF

• The symmetrical behaviour of carbon nanotubes junctions

  T.I. Pataki, Z. Szakál

  128-133

  • PDF

• Comparing strength properties of natural and synthetic rubber mixtures

  T. Renner, L. Pék

  134-141

  • PDF

• Novel cylinder positioning system realised by using solenoid valves

  L Földi, Z. Béres, E. Sárközi

  142-151

  • PDF

• Symmetry and similarity properties of 2D figures

  Z. Szakál, I. Zsoldos

  152-159

  • PDF